Filter
Top Products
Adding memory and replacing the CPU
Issue 3.3 February 2003 151
7. Repeat this procedure for each DIMM.
8. Replace the diskette/disk drive bracket and tighten the screws that hold the bracket.
Closing the computer
To close the computer:
1. If you removed the PCI card from Slot 2 earlier, reinstall it now.
2. Reconnect the AC power cord to the computer.
3. Detach the ESD wrist strap.
4. Replace the cover on the computer. Slide the cover forward until it fits snugly around
the chassis.
5. Replace the two cover screws.
Tip:
Tip : Install each screw with just a few turns before you tighten both screws.
Checking the new memory size
To check the new memory size:
1. Turn on all external SCSI devices starting with the device that is farthest from the
system and working toward the system.
2. Turn on the system monitor.
3. Turn on the system.
4. When the system comes up, log in as root.
5. Enter:
prtconf | grep Memory
This displays the new memory size.
6. Verify that the displayed memory size is correct, comparing it to the value recorded
before you added the new memory. If the new figure is not correct, power down the
system and check that all memory modules are properly seated.
Memory size: xxx Megabytes