Filter
Top Products
Maintenance
74 Avaya CMS Sun Ultra 5 Computer Hardware Installation, Maintenance, and Troubleshooting
Removing an SAI/P card – To remove an SAI/P card:
1. Verify that you have a recent CMSADM file system backup before you change card
configurations.
2. Enter the following commands:
sacadm -l
pmadm -l
These commands display existing administration information. Record this information
for later use.
3. Enter:
pmadm -r -p ttysaipslot -r ttyportdesignator
This removes port administration for all SAI/P cards, where slot indicates slot a or
slot b, and portdesignator is the full SAI/P port designation (a000, a001, and so
on).
4. Remove the SAI/P software drivers. Refer to Removing SAI/P drivers and utilities
on
page 75.
5. Enter:
/usr/sbin/shutdown -y -i0 -g0
This shuts down the system.
6. Turn off the system.
7. Turn off the system monitor.
8. Turn off all external SCSI devices starting with the device that is closest to the system
and working toward the farthest device.
9. Remove the SAI/P card from the system. See Installing or removing
PCI cards on
page 66 for more information.
10. Turn on all external SCSI devices starting with the device that is farthest from the
system and working toward the system.
11. Turn on the system monitor.
12. Turn on the system.
13. Press Stop+A simultaneously after the console banner is displayed, but before the
system starts booting.
14. Enter:
boot -r
This reboots the system so that it recognizes the new configuration.
15. Readminister all terminals, modems, and printers connected to the SAI/P expander
box.