Avaya 585-215-871 Network Hardware User Manual


 
Maintenance
70 Avaya CMS Sun Ultra 5 Computer Hardware Installation, Maintenance, and Troubleshooting
SCSI devices are addressed as shown in the table below. These addresses are set
using the Target Address Switches on the back of each SCSI device.
11. Remove the ESD wrist strap.
12. Reattach the cover.
13. Reconnect the AC power cord.
14. Turn on all external SCSI devices starting with the device that is farthest from the
system and working toward the system.
15. Turn on the system monitor.
16. Turn on the system.
17. Press Stop+A simultaneously after the console banner is displayed, but before the
system starts booting.
18. Enter:
boot -r
This reboots the system so that it recognizes the new configuration.
19. Perform a CMSADM file system backup to back up the updated system configuration.
See your CMS software installation, maintenance, and troubleshooting document for
details.
Device Address
Disk Drive 1 0
Disk Drive 2 1
Disk Drive 3 2
Disk Drive 4 3
Tape Drive 1 4
Tape Drive 2 5
!
Important:
!
Important:
Important: Do not use a target address
greater than 5.