Avaya 585-215-871 Network Hardware User Manual


 
Maintaining disk drives
Issue 3.3 February 2003 83
Maintaining disk drives
Overview
Procedures in this section include the following:
Disk drive compatibility with CMS loads on page 83
Prerequisites on page 83
Required references on page 84
Replacing the primary internal EIDE boot disk drive on page 85
Adding or replacing the internal EIDE data disk drive on page 93
Adding or replacing external SCSI disk drives on page 102
Setting up the disk drives on page 110.
Partitioning disk drives on page 111
Administering data disk drives on page 121
Disk drive compatibility with CMS loads
When a new or replacement disk drive is installed in an older system, the CMS load may
not be compatible with the disk drive if the CMS configuration files have not been updated.
These configuration files (/olds/disk.conf and /olds/olds-funcs) must be edited
or replaced with the correct information. Contact the Avaya technical support organization
for assistance.
Prerequisites
Do a CMSADM backup, if possible, before you add or replace a disk drive. See your CMS
software installation, maintenance, and troubleshooting document for this procedure.
Before you attempt to replace defective data (nonboot) disks, try to print the current setup
for all ACDs. This information must be readministered after you install replacement disks.