Filter
Top Products
Maintenance
90 Avaya CMS Sun Ultra 5 Computer Hardware Installation, Maintenance, and Troubleshooting
5. Slide the mounting bracket into place, routing the EIDE ribbon cable so that the
MOTHER BOARD connector can reach the connector on the motherboard, and the
SLAVE connector can reach the secondary internal disk drive.
6. Attach the mounting bracket to the chassis using the two screws saved earlier. See the
following figure.
7. Connect the EIDE ribbon cable end labeled MOTHER BOARD to the EIDE connector
on the mother board.
Tip:
Tip : If you are also replacing the secondary internal data disk drive, wait and
attach the EIDE ribbon cable to the mother board after you install that drive.
8. Do one of the following:
● If you are adding or replacing the secondary data disk drive, continue with Adding or
replacing the internal EIDE data disk drive on page 93.
● If you are not adding or replacing the secondary data disk drive, continue with
Closing the computer
on page 91.
u5_master_install.cdr