Filter
Top Products
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
104 Avaya P330-ML Reference Guide
Example:
set port trap
User level: privileged, supervisor.
Use the set port trap command to enable or disable generic SNMP uplink or
downlink traps from a port.
The syntax for this command is:
set port trap <module>/<port> {enable|disable}
Example:
set port vlan
User level: privileged, supervisor.
Use the set port vlan command to set the port VLAN ID (PVID). If adding a
new VLAN, the VLAN number must be within the range 1 to 3071.
L You need to define a vlan before setting a port VLAN ID.
The syntax for this command is:
set port vlan <vlan_num> <module>/<port>
P330-N# set port static-vlan 3/4-6 2
VLAN 2 is bound to port 3/4
VLAN 2 is bound to port 3/5
VLAN 2 is bound to port 3/6
module Number of the switch.
port Number of the port on the switch.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
enable Enable uplink/downlink traps
disable Disable uplink/downlink traps
P330-N# set port trap 3/2 enable
Port 3/2 up/down trap enabled.
vlan_num Number identifying the VLAN.