Filter
Top Products
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
222 Avaya P330-ML Reference Guide
included in the configuration file. Therefore, it is important to reinitialize the
NVRAM to the factory default settings before downloading configuration files
to the switch. To reinitialize the NVRAM, run the nvram initialize
command.
The syntax for this command is:
copy tftp startup-config <filename> <ip>
Example:
disconnect ssh
User level: supervisor
Use the disconnect ssh command to disconnect an SSH session.
The syntax for this command is:
disconnect ssh <session-id>
Example:
erase startup-config
Use the erase startup-config command to clear the startup configuration.
The syntax for this command is:
erase startup-config
filename file name (full path)
ip The ip address of the host
Router-N> copy tftp startup-config c:\P330-ML\router1.cfg
192.168.49.10
session-id The SSH session ID. Use the show ssh command to
learn an SSH session ID.
P330-ML-2# disconnect ssh 0x508622f0
You are about to close this session - do you want to
continue (Y/N)? y
Closing session 0x508622f0