Filter
Top Products
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide 291
Router RIP Context
L You can only access these commands in the “Router-RIP” context.
Type router rip at the command prompt to enter the “Router-RIP” context if
necessary.
network
User level: privileged, supervisor.
Use the network command to specify a list of networks on which the RIP is
running.
Use the no network command to remove an entry.
The syntax for this command is:
[no] network <ip-address> [<wildcard-mask>]
Example:
To specify that RIP will be used on all interfaces connected to the network
192.168.37.0:
redistribute
User level: privileged, supervisor.
Use the redistribute command to redistribute routing information from other
protocols into RIP.
Use the no redistribute command to disable redistribution by RIP.
The default is disabled.
The syntax for this command is:
[no] redistribute <protocol>
ip addr The IP address of the network of directly connected networks
wildcard-mask Wildcard mask address. Exists for compatibility with P550.
Router-N(configure router:rip)# network 192.168.37.0
Done!
protocol Either Static or OSPF