Filter
Top Products
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 201
snmp-server enable
User level: supervisor
Use the snmp-server command to enable SNMP Access to the switch.
The syntax for this command is:
snmp-server enable [volatile]
Example:
snmp-server enable notifications
User level: supervisor
Use the snmp-server enable notifications command to enable sending all
Simple Network Management Protocol (SNMP) notifications (traps and informs).
The syntax for this command is:
snmp-server enable notifications
Example:
snmp-server engineID
User level: supervisor
Use the snmp-server engineID command to change the SNMP Engine ID. Only
the default user can run this command.
volatile
(Optional)
By default the activation of the snmp-server command is
permanent and automatically stored in the non-volatile
memory. The SNMP server is automatically launched after all
restarts. If the volatile parameter is provided, then the SNMP
service runs only until the stack is reset.
P330-N>snmp-server enable
Done!
P330-N>snmp-server enable notifications
Done!