Filter
Top Products
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 39
ip access-default-action
User level: supervisor
L This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the ip access-default-action command to set the default action for a
specific policy list.
The syntax for this command is:
ip access-default-action <policy-list-number> <default-
action>
Example:
ip access-list-dscp operation
User level: supervisor
L This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the ip access-list-dscp operation command to set a DSCP to CoS
mapping. The system performs the mapping for only those frames than match an
ACL rule with a ‘permit’ action.
The syntax for this command is:
ip access-list-dscp operation <policy-list-number> <dscp>
<action>
<policy-list-number> integer (100...149)
<default-action> default-action-deny|default-action-permit
Router-N# access-default-action 101 default-action-deny
Done!
policy-
list-
number
A valid id number for a policy list currently defined for the module
(100..149)
dscp DSCP value or range of DSCP