Filter
Top Products
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
42 Avaya P330-ML Reference Guide
ip http enable
User level: supervisor
Use the ip http enable command to enable HTTP access to the device.
The syntax for this command is:
ip http enable
Example:
ip icmp redirect
User level: supervisor
Use the ip icmp redirect command to enable ICMP redirects via the device.
The syntax for this command is:
ip icmp redirect
Example:
ip simulate
User level: supervisor
L This command applies to the P334T-ML only when it is in device mode
"Layer2".
Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
The syntax for this command is:
ip simulate <policy-list-number> [<priority>] [<dscp-
value>]<source> <destination> [<protocol> [<source port>
<destination port> [<established>]]]
P330-N# ip http enable
Done!
P330-N# ip icmp redirect
Done!
policy-list-number integer (100...149, 0-default list)
priority fwd0 | fwd1 | ... | fwd7
dscp-value dscp0 | dscp1 | ... | dscp63