Filter
Top Products
Chapter 2 Avaya P330-ML Layer 2 CLI Commands
Avaya P330-ML Reference Guide 123
L This command can only be run from the console port on the device.
The syntax for this command is:
set terminal recovery password enable
Example:
set time client
User level: privileged, supervisor.
Use the set time client command to enable or disable the periodic network
time acquisition by the switch from the network time server (SNTP or TIME
protocol).
The syntax for this command is:
set time client {enable|disable}
Example:
set time protocol
User level: privileged, supervisor.
Use the set time protocol command to set the protocol for use in the system as
either SNTP protocol or TIME protocol.
The syntax for this command is:
set time protocol [sntp-protocol|time-protocol]
P330-N# set terminal recovery password enable
Done!
enable Enable periodic network time acquisition
disable Disable periodic network time acquisition
P330-N# set time client enable
Time client mode enabled
sntp-protocol Use the SNTP protocol
time-protocol Use the TIME protocol