Filter
Top Products
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
238 Avaya P330-ML Reference Guide
Use the ip routing command to enable IP routing.
Use the no ip routing command to disable the IP routing process in the device.
By default, IP routing is enabled.
The syntax for this command is:
[no] ip routing
Example:
ip simulate
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the ip simulate command to check the policy for a simulated packet. The
command contains the addressed list number, and the packet parameters.
The syntax for this command is:
ip simulate <access-list-number> [<priority>] [<dscp-
value>]<source> <destination> [<protocol> [<source port>
<destination port> [<established>]]]
Router-N(configure)# ip routing
Router-N(configure)#
access-list-number nteger (100 - 149, 0 is the default list)
priority fwd0 | fwd1 | - | fwd7
dspc value dscp0 | dscp1 | - | dscp63
source source ip address
destination destination ip address
protocol ip | tcp | udp | integer (1 - 255)
source port integer (1 - 65535)
destination port integer (1 - 65535)
established value of TCP established bit