Filter
Top Products
Avaya P330-ML Reference Guide 1
Chapter 1
Using the CLI
This chapter describes the Avaya P330 CLI architecture and conventions, and
provides instructions for accessing the Avaya P330 for configuration purposes.
The configuration procedure involves establishing a Telnet session or a serial
connection and then using the Avaya P330’s internal CLI.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, you must type the desired command at the prompt and press
Enter.
You can also configure your Avaya P330 using the P330 Manager with its graphical
user interface. For details, see the switch User’s Guide and the Avaya™
MultiService Network Manager P330 Device Manager User’s Guide on the
Documentation and Utilities CD.
CLI Architecture
The P330 stack supports both Layer 2 switching and Layer 3 routing (Layer 3
functionality depends on the module type).
The P330 CLI includes two CLI entities to support this functionality.
• The Switch CLI entity is used to manage Layer 2 switching of the entire stack.
The Switch CLI entity is identical to the CLI of a P330 Layer 2 modules.
CLI commands for managing Layer 2 switching are described in Chapter 2.
• The Router CLI entity is used to manage Layer 3 routing of a single module. The
Router CLI entity exists only in Layer 3 modules (P333R, P333R-LB and
P330-ML). CLI commands for managing Layer 3 routing are described in
Chapter 3.
If the Layer 3 module is the Stack Master, then the Switch CLI entity and the Router
CLI entity co-exist on the same module.
To switch between the entities, use the session command.
Configuration of the password commands and community commands in one
entity is automatically attributed to the other entity in the stack.
Initial access to the stack can be established via a serial connection or a Telnet
connection to any one of the entities.