Filter
Top Products
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide 243
L When you use the session command the security level stays the same.
Example:
L The security level stays the same when you use the session command.
set device-mode
User level: privileged, supervisor.
Use the set device-mode command to change the basic mode of operation of the
switch between Router and Layer 2 modes.
L This command is available on P330-ML-ML and P333R switches only.
The syntax for this command is:
set device-mode <mode>
Example:
switch|router|atm|mgp|wan (optional) The entity to which you want to
open a session.
If you do not specify this parameter, you will
get the default entity of the specific module:
switch - Layer 2 entity of the switch (see Note
below).
router - Routing entity.
atm - ATM entity.
mgp - Media Gateway Processor.
wan - WAN access router entity.
Router-1> session 2
Router-2>
mode Router | Layer2
Router-N> set device-mode Layer2
This command will RESET the device
*** Reset *** - do you want to continue (Y/N)? y