Filter
Top Products
Avaya P330-ML Reference Guide 211
Chapter 3
Avaya P330-ML Layer 3 CLI Commands
This chapter provides all the Layer 3 CLI (Command Line Interface) commands,
parameters, and their default values.
How the Layer 3 CLI is Organized
The commands that make up the Layer 3 CLI are organized alphabetically and
according to context.
Router Configuration Contexts
You can either use the general Layer 3 commands available from the
Router(configure)# prompt or you can enter one of two router configuration
context modes:
Router interface context
Allows you to define parameters individually for each interface. To enter this
context, type
interface <interface_name>
The prompt changes to
Router-N(config-if:<interface_name>)#
Router protocol context
Allows you to define parameters for a specific routing protocol (RIP, OSPF, and
SRRP). To enter this context, type
router <protocol_name>
The prompt changes to
Router-N(config router:<protocol_name>)#
To exit these context modes, type the command
exit.
Shortcuts to Commands by Context
Command descriptions are organized into the following contexts:
General Commands Page 212
Interface context Commands Page 274
Router RIP context Commands Page 291
Router OSPF context Commands Page 293
Router SRRP context Commands Page 296