Filter
Top Products
Chapter 3 Avaya P330-ML Layer 3 CLI Commands
Avaya P330-ML Reference Guide 213
The syntax for this command is:
[no] arp timeout <seconds>
Example:
To set the arp timeout to one hour:
To restore the default arp timeout:
clear arp-cache
User level: privileged, supervisor.
L If you are at the ”privileged” level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter configure mode.
Use the clear arp-cache command to delete dynamic entries from the ARP
cache and the IP route cache.
The syntax for this command is:
clear arp cache[<vlan>|<ip addr>[<mask>]]
Example:
seconds The amount of time, in seconds, that an entry remains
in the arp cache.
Router-N(configure)# arp timeout 3600
Router-N(configure)# no arp timeout
vlan VLAN string (up to 16 characters)
ip addr IP address
mask IP mask
Router-N(configure)# clear arp-cache
Flushing all arp entries
Flushed 100 ARP entries
Done!