Filter
Top Products
Cause Corrective Action
(When you have attempted to print a test print sheet or
other printer status information.)
(See "Removing the Roll from the Printer.") ➔P.345
(See "Removing the Roll Holder from Rolls.") ➔P.347
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Loading Rolls on the Roll Holder.") ➔P.337
(See "Loading Rolls in the Printer.") ➔P.339
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume
printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the
printer driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") ➔P.345
(See "Removing the Roll Holder from Rolls.") ➔P.347
2.
Replace with paper of the width configured in the printer driver.
(See "Loading Rolls on the Roll Holder.") ➔P.337
(See "Loading Rolls in the Printer.") ➔P.339
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you se-
lect Fit Roll Paper Width in the printer driver matches the width of the roll
loaded in the printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload the
paper.
(See "Loading Rolls in the Print-
er.") ➔P.339
(See "Loading Sheets in the Print-
er.") ➔P.360
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the
Roll Holder flange, and reload the Roll
Holder in the printer.
(See "Loading Rolls on the Roll Hold-
er.") ➔P.337
Because the Platen is soiled with ink or other substances, the size of the clear film
cannot be detected.
Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cov-
er.") ➔P.564
Insufficient paper for job
Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
PaprWidth Mismatch
iPF8400SE
User's Guide
Error Message Messages regarding paper
614