Filter
Top Products
Setting Item Description, Instructions
Mainte-
nance
Change Cutter Replace the Cutter Unit. Follow the instructions displayed
to complete the required procedure. (See "Replacing the
Cutter Unit.") ➔P.554
Once you replace the Cutter Unit, you can also reset the
cut counter.
Inter-
face
Setup
EOP Timer Specify the timeout period before cancellation of print jobs
that cannot be received by the printer.
TCP/IP IPv4 IPv4 Mode Choose whether the printer IP address is configured auto-
matically or a static IP address is entered manually.
Proto-
col
DHCP Specify the protocol used to configure the IP address au-
tomatically.
BOOTP
RARP
IPv4
Settings
IP Address Specify the printer network information when using a stat-
ic IP address.
Enter the IP address assigned to the printer, as well as
the network subnet mask and default gateway.
The value that was automatically configured is displayed if
you have set IPv4 Mode to Automatic.
Subnet Mask
Default G/W
DNS
Settings
DNS Dync update Specify whether DNS server registration is updated auto-
matically.
Pri. DNS SrvAddr Specify the DNS server address.
Sec. DNS SrvAddr
DNS Host Name Specify the DNS host name.
DNS Domain Name Specify the DNS domain name.
IPv6 IPv6 Support Specify whether to connect via IPv6.
IPv6 StlessAddrs Specify whether a IPv6 stateless address is used.
DHCPv6 Specify whether DHCPv6 settings are used.
DNS
Settings
DNS
Dync
update
Statefull
Addr
Specify whether DNS server registration is updated auto-
matically.
State-
less
Addr
Pri. DNS SrvAddr Specify the DNS server address.
Sec. DNS SrvAddr
DNS Host Name Specify the DNS host name.
DNS Domain Name Specify the DNS domain name.
Net-
Ware
NetWare Specify the NetWare protocol. To apply your changes,
choose Register Setting.
Frame Type Specify the frame type to use.
Print Service Choose the print service.
AppleTalk Specify whether to use the AppleTalk protocol. To apply
your changes, choose Register Setting.
Ether-
net
Driver
Auto Detect Specify the communication method. To apply your
changes, choose Register Setting.
Choose On for automatic configuration of the LAN com-
munication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Comm.Mode Choose the LAN communication method.
Ethernet Type Choose the LAN transfer rate.
Spanning Tree Choose whether spanning-tree packets are supported
over the LAN.
iPF8400SE
Menu Settings
User's Guide
Control Panel Printer Menu
451