Filter
Top Products
5-6
Cisco MGX 8220 Installation and Configuration
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Chapter
AUSM Connections
AUSM Connections
AUSM connections can be setup either through CWM or via the CLI.
Via Cisco WAN Manager
Setting up an AUSM connection is normally performed from Cisco WAN Manager (CWM) using the
Connection Manager graphical user interface (GUI). An example of the CWM screen used for making
an MGX 8220 ATM-to-ATM connection is shown in Figure 5-3. For full details of how to set up a
connection, refer to the Cisco WAN Manager Operations Guide.
Figure 5-3 ATM to-ATM Connection Screen
Via the Command-Line Interface
Use the following sequence of commands to establish an ATM UNI/NNI connection using the AUSM
card. The connection is between a T1 or E1 ATM UNI on the AUSM card and an ATM service interface
elsewhere in the IPX/BPX network.
1. Log in to AUSM.
2. Enter the addln command. Specify the line and port number (between 1 and 4 on a 4-port card;
between 1 and 8 on an 8-port card), 1 being the top line and port.
3. If required, enter the cnfln command specifying line code, line length, and clock source.
4. Enter the upport command specifying the port to be upped.