Filter
Top Products
8-19
Cisco MGX 8220 Installation and Configuration
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Chapter
Log Codes
6155 Rate Control feature
changed to
Rate control feature is changed. Whether it is turned
on or off is displayed.
6157 AUSM got time from ASC AUSM received date and time from the ASC.
6165 ASC request to go to default AUSM received message from ASC to use default
values for configuration.
6166 AUSM using the default
Config.
AUSM card is using default values for configuration
parameters.
6167 ASC sent slot number to SM AUSM received slot information from ASC. Displays
the slot number after validation.
6170 Added Egress Queue A new egress queue has been added. Egress queue
number is displayed.
6171 Deleted Egress Queue An egress queue is deleted, queue number is
displayed.
6172 Modified Egress Queue Egress queue is modified, queue number is displayed.
6201 CSE decision not read Cell DMA has not read the service decision for Egress
queue servicing.
6202 CSE Enable Failed Cell service engine enable failed.
6221 Invalid Connection Request Connection request from CDMA is neither for VCC
or VPC connection.
6222 PLPP write FIFO full Failed while trying to write to PLPP FIFO.
6223 CDMA Exception A CDMA exception has occurred.
6224 Duplicate Connection Open Found a duplicate entry while trying add to address
translation table.
6225 Unknown connection close Did not find entry in address translation table for
closing.
6226 IBS queue full Found IBS queue full while trying to enqueue cell.
6227 ABR queue full Found ABR queue full while trying to enqueue cell.
6228 No free ingress data buffers Could not find free buffer from ingress free data pool.
6229 No free ingress ILMI buffers Could not find free buffer from ingress ILMI free
pool.
6230 No free ingress OAM
buffers
Could not find free buffer from ingress OAM-ree pool
6231 cellDmaEnablePort Failed Failed trying to enable CDMA for a port. Port number
is displayed.
6241 CDMA Ping Error Cell DMA module is not responding.
6242 Error from CDMA Cell DMA reports error. Addtional information on the
specific instance is displayed.
6224 Cannot Load CDMA
firmware
Unable able to load CDMA firmware.
6225 Cell DMA Enable Failed Failed to enabled cell DMA.
Table 8-6 AUSM Log Codes (continued)
Error Number Display Log String Detail Description