Filter
Top Products
5-13
Cisco MGX 8220 Installation and Configuration
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Chapter
FRASM Connections
addport <port_num> <line_num> <line_speed> <begin_slot> <port_type> <port_role> <encoding>
<interface>
4. Enter the add BSTUN port command (addbstunport) to establish a group number for the
connection.
addbstunport<port_num><group_num>
5. Enter the add channel (addchan) command to specify the Frame Relay portion of the connection.
This consists of specifying the DLCI and committed information rate (cir) for the channel.
addchan <chan_num> <port_num> <dlci_num> <cir>
6. Enter the add BSTUN route command (addbstunroute) to establish a connection between the
Frame Relay channel number and the 3270 control unit.
<port_num> port number in the range 1–192
<line_num> value ranging from 1–8
<line_speed> 1 for 2.4K, 2 for 4.8K, 3 for 9.6K, 4 for 56K, 5 for 64K
<begin_slot> time slot number in the T1 frame
<port_type> 1, 2, or 3: 1 = STUN, 2 = FRAS, 3 = BSTUN
<port_role> 1, 2, 3, or 4: 1 = Primary, 2 = Secondary, 3 = Negotiable
<encoding> 1 or 2: 1 = NRZ, 2 = NRZI
<interface> 1 or 2: 1 = DS0, 2 = DS0A
<port_num> port number in the range 1–192
<group_num> group number to which the connection is to be assigned
<chan_num> channel number is in the range 16–1015
<port_num> port number is in the range 1–192
<dlci_num> DLCI is in the range 0–1023
<cir> committed information rate: 0–1536000 bps for T1; 0–2048000 bps
for E1 (FRASM does not support E1)