Filter
Top Products
4-50
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 4 Configuring VISM Features
Configuring VISM Features
Complete the following steps to configure ISDN PRI backhaul:
Step 1 Type the addsesset command, set-num and fault-tol-enable argument values, and press Enter to create
a session set. Specify the arguments with the following values:
• set-num: In the range from 1 to 16
• fault-tol-enable:
–
1 = Yes
–
2 = No
Step 2 Type the addsesgrp command, group-num, set-num, and mgc-name argument values, and press Enter
to create a session group for a session set and a call agent. Specify the arguments with the following
values:
• group-num: In the range from 1 to 16
• set-num: In the range from 1 to 8
• mgc-name: A text string of up to 64 alphanumeric characters
Step 3 Type the addses command, session-num, group-num, priority, local-port-num, and remote-port-num
argument values, and press Enter to create an ISDN PRI backhaul RUDP session within a specified
group. Specify the arguments from the following values:
• session-num: In the range from 1 to 64
• group-num: In the range from 1 to 16
• priority: In the range from 1 (highest) to 4 (lowest)
• local-port-num: The VISM port number you want to use for the session
• remote-port-num: The call agent (remote) port number you want to use for the session
Note The following session configuration commands apply to a single session which is identified by the
first argument, the session-num.
Step 4 Type the cnfsesack command, session-num, ack-timeout, and max-acks argument values, and press
Enter to change the timeout period for sending out an acknowledgment and the maximum number of
acknowledgments that can accumulated before sending them. Specify the arguments with the following
values:
• session-num: In the range from 1 to 64
• ack-timeout (defined in milliseconds): In the range from 100 to 65535
• max-acks: In the range from 0 to 255
Step 5 Type the cnfsesmaxreset command, session-num and max-resets argument values, and press Enter to
configure the maximum number of resets that VISM performs before a connection is reset. Specify the
arguments with the following values:
• session-num: Type the value entered for the session-num argument in Step 4.
• max-resets: In the range from 0 to 255