Filter
Top Products
5-7
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
addccs
addccs
To add a common channel signaling (CCS) channel (D channel) to a VISM card, use the addccs
command in the switched AAL2 PVC and AAL2 trunking operating modes.
addccs line-num ds0-num lcn
Syntax Description
Command Modes Switched AAL2 PVC and AAL2 trunking
Usage Guidelines To use this command, you must select CCS signaling on the specified line with the cnflnsig command.
When you execute this command, a value called ds0IfIndex is displayed, which is used to identify the
CCS channel in subsequent CCS-related commands.
Examples The following example shows that a CCS D channel is added to line 1, DS0 20, logical channel number
200:
addccs 1 20 200
Related Commands
line-num Line number of the channel to be added in the range from 1 to 8.
ds0-num DS0 number of the channel to be added. It can be a value from one of the following
ranges:
• 1 to 24 for T1 lines
• 1 to 31 for E1 lines
lcn Logical channel number of the CCS channel to be added in the range from 131 to
510.
Command Description
delccs Deletes the association between a CCS (DS0) channel and its corresponding virtual
channel.
dspccs Displays the properties of a previously added CCS channel.