Filter
Top Products
5-209
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfsesoutofseq
cnfsesoutofseq
To configure the maximum number of out-of-sequence packets that can be accumulated before sending
an EACK packet, use the cnfsesoutofseq command in the VoIP switching/trunking operating mode.
cnfsesoutofseq session-num max-seq-pkts
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that a maximum of 10 out-of-sequence packets can be accumulated before
an EACK packet is transmitted for session number 2:
cnfsesoutofseq 2 10
Related Commands
session-num Identifying session number in the range from 1 to 64.
max-seq-pkts The maximum number of out-of-sequence packets that can be accumulated
before an EACK packet is transmitted. It can be in the range from 0 to 255.
Note If you specify 0, a DACK message is sent immediately upon
receiving an out-of-sequence packet.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.