5-89
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfcascode
cnfcascode
To configure channel associated signaling (CAS) idle code and seized code parameters for an endpoint,
use the cnfcascode command in the AAL2 trunking operating mode.
cnfcascode endpt-num idle-code seized-code |endpts-num|
Syntax Description endpt-num The endpoint number which is to be configured with CAS idle code and seized code
values. It can be a value from one of the following ranges:
• For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
• For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 4:
–
For VISM-PR, from 1 to 144
Note If the second (optional) endpt-num argument is specified, this argument value
is the first endpoint in a consecutive number of endpoints.
idle-code The 4-bit idle code. The value can be in the range from 0 to 15 and represents the four
signaling bits—A, B, C, and D—in binary, as bits 3, 2, 1, and 0 respectively, with bit
3 the most significant.