Filter
Top Products
5-96
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfcasglareattrib
cnfcasglareattrib
To configure the direction of channel associated signaling (CAS) calls and the glare (dual seizure event)
policy for a specified endpoint, use the cnfcasglareattrib command in the VoIP switching/trunking,
switched AAL2 PVC, and AAL2 trunking operating modes.
cnfcasglareattrib endpt-num cas-direction glare-pol
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Use this command to assist in controlling TDM glare events. Use the cas-direction argument to allow or
disallow glare events. Use the glare-pol argument value to configure the resolution of glare events if you
allow them to occur. Resolution of glare events is either to enable VISM to release a call and accept a
call from the PBX, or wait for the PBX to release a call and enable VISM to continue with a call.
endpt-num Endpoint number which is to be configured with CAS call direction and a glare
policy. It can be a value from one of the following ranges:
• For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
• For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 4:
–
For VISM-PR, from 1 to 144
cas-direction CAS bits flow direction. It can be one of the following values:
• 1 = Incoming and outgoing
• 2 = Incoming
• 3 = Outgoing
glare-pol Glare condition policy. It can be one of the following values:
• 1 = Controlling
• 2 = Releasing
Note You can assign a glare-pol argument value of 2 only if the cas-direction
argument is assigned a value of 1.