Filter
Top Products
5-346
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
dspendpt
dspendpt
To display configuration data of a specified VISM card endpoint, use the dspendpt command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
dspendpt endpt-num
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data of endpoint number 120 is displayed:
dspendpt 120
EndptNum: 120
EndptLineNum: 1
EndptName: T1-1/1@cisco.com
EndptSpeed: 64 kbps
EndptState: active
EndptChannelMap: 1
EndptEnable: active
EndptLoopback: disabled
Note The EndptChannelMap value is represented by a hexadecimal number, where each DS0 is a power
of 2—EndptChannelMap = 2
DS0 number
.
endpt-num Endpoint number. It can be a value from one of the following ranges:
• For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
• For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 4:
–
For VISM-PR, from 1 to 144