5-161
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnflapdtype
cnflapdtype
To configure the various types of Link Access Protocol D channel (LAPD) stacks for a previously added
LAPD, use the cnflapdtype command in the VoIP switching/trunking operating mode.
cnflapdtype line-num ds0-num lapd-type
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that line 2, DS0 12 is configured with the AUSP LAPD stack type:
cnflapdtype 2 12 12
line-num Line number of the D channel to be configured. In the range from 1 to 8.
ds0-num DS0 number that was specified in the addlapd command. It can be a value from one of
the following ranges:
• 1 to 24 for T1 lines
• 1 to 31 for E1 lines
lapd-type Type of LAPD stack to configure on the specified line and DS0. It can be one of the
following values:
• 1 = ITU
• 3 = ATT5ESSPRA
• 4 = ATT4ESS
• 6 = NTDMS100PRA
• 7 = VN2 or 3
• 8 = INSNet
• 9 = TR6MFC
• 10 = TR6PBX
• 12 = AUSP
• 13 = NIL
• 14 = SSETSI
• 15 = BC303TMC
• 16 = BC303CSC
• 17 = NTDMS250
• 18 = Bellcore
• 19 = NI2