Filter
Top Products
5-11
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
addcid
• The current DSP template must contain the desired codec type.
This command can be used on an endpoint that has no associated CAS variant. However, if a CAS variant
is specified for the endpoint, it must be Q.50 variant (file q50.o)—the only CAS variant supported by
this command.
The G.723.1 codecs are supported for VISM-PR cards and are not supported for VISM cards.
Examples The following example creates a CID for endpoint 10, LCN 140, with a CID number of 10. The codec
type is 2 (G.711a), profile type is 1 (ITU), profile number is 1 (ITU), VAD is 1 (on), VAD holdover is
300 milliseconds, type 3 redundancy is 1 (on), CAS transport is 1 (on), DTMF transport is 1 (on), idle
code suppression is 1 (on) and the packet period is 10 milliseconds.
addcid 10 140 10 2 1 1 1 300 1 1 1 10
Related Commands Command Description
delcid Deletes the association between an endpoint and an LCN/CID pair.
dspcid Displays the argument values of an AAL2 CID on a VISM card.
dspcids Displays all the AAL2 CIDs for a specified LCN on a VISM card.