Filter
Top Products
5-206
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfsesmaxseg
cnfsesmaxseg
To configure the maximum segment size, in octets, that can be received by a VISM card after sending a
synchronize message, use the cnfsesmaxseg command in the VoIP switching/trunking operating mode.
cnfsesmaxseg session-num seg-size
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that a maximum 1000-octet segment size is configured for session number
2:
cnfsesmaxseg 2 1000
Related Commands
session-num Identifying session number in the range from 1 to 64.
seg-size Maximum segment size, in octets, that can be received by a VISM card after
sending a synchronize message. It can be in the range from 30 to 65535.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxwindow Configures the maximum number of segments (window) that can be sent
before receiving an acknowledgment.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.