Filter
Top Products
5-382
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
dspmgcgrpparams
dspmgcgrpparams
To display all configured Media Gateway Control Protocol (MGCP)—call agent—redundancy group
parameters, use the dspmgcgrpparams command in the VoIP switching/trunking and switched AAL2
PVC operating modes.
dspmgcgrpparams
Syntax Description This command has no arguments or keywords.
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that all configured call agent redundancy group parameters are displayed:
dspmgcgrpparams
Mgc Grp Num Com State State Chg Notification Priority
----------- --------- ---------------------- --------
1 CommLoss Enabled 1
Related Commands Command Description
addmgcgrpentry Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
addmgcgrpprotocol Associates a call agent redundancy group to a gateway control protocol.
cnfmgcgrpparam Modifies a call agent redundancy group state change notification policy
and priority level.
cnfmgcgrpentry Modifies the call agent priority level of a call agent within a call agent
redundancy group.
cnfsrcppeer Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
cnfsrcppeergrpparam Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
delmgcgrpentry Deletes a call agent from a call agent redundancy group.
delmgcgrpprotocol Deletes an MGCP from a specified call agent redundancy group.
dspmgcgrpprotocols Displays all configured call agent redundancy group protocols.
dspmgcgrps Displays all configured call agent redundancy groups.
dspsrcppeergrpparams Displays the SRCP parameters for all call agent redundancy groups that
have SRCP added.