5-255
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
delendpts
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines This command results in a graceful transition to the out-of-service state for each deleted endpoint and
an RSIP to be sent to each associated call agent indicating the out-of-service state of the endpoints.
If the specified range of endpoints to be deleted contains gaps, the gaps are not counted. For example, if
the current endpoints are 3, 4, 7, 8, 9 10, 11,12 and the command specifies a start at 4 and a number of
5, the endpoints deleted are 4, 7, 8, 9, and 10.
Examples The following example shows that 10 endpoints are deleted, starting with endpoint number 120:
delendpts 120 10
Related Commands Command Description
addendpt Adds an endpoint on a VISM card.
dspendpt Displays data about a specified endpoint on a VISM card.
dspendpts Displays data about all endpoints on a VISM card.