5-91
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfcasdialdelay
cnfcasdialdelay
To configure the VISM wait time (dial delay) for outpulsing digits to the PBX after sending an off-hook
event, use the cnfcasdialdelay command in the VoIP switching/trunking and switched AAL2 PVC
operating modes.
cnfcasdialdelay endpt-num dial-delay
Syntax Description
Command Modes VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines You can execute this command if the following conditions are met:
• The endpoint represented by the endpt-num argument value has been previously added.
• The associated DS0 is configured for CAS.
• The protocol is immediate start.
• The MIB was chosen as the source in the cnfcasparamsource command.
Examples The following example shows that endpoint 100 is configured with a dial delay (wait time) of 50 ms:
cnfcasdialdelay 100 50
endpt-num The endpoint number to which the outpulsing digits wait time is configured. It can be
a value from one of the following ranges:
• For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
• For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 4:
–
For VISM-PR, from 1 to 144
dial-delay The wait time (defined in milliseconds) for outpulsing digits to the PBX after sending
an off-hook event. It can be in the range from 10 to 1000. (Default = 500)