Filter
Top Products
5-205
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfsesmaxreset
cnfsesmaxreset
To configure the maximum number of resets that a VISM card performs before a connection is reset, use
the cnfsesmaxreset command in the VoIP switching/trunking operating mode.
cnfsesmaxreset session-num max-resets
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Use this command for a previously added PRI backhaul session.
Examples The following example shows that 25 is the maximum number of resets configured for session number 2:
cnfsesmaxreset 2 25
Related Commands
session-num Identifying session number in the range from 1 to 64.
max-resets Maximum number of resets that the VISM card performs before a
connection is reset. It can be in the range from 0 to 255. (Default = 3)
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
cnfsesmaxwindow Configures the maximum number of segments (window) that can be sent
before receiving an acknowledgment.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
cnfsesport Configures the port numbers of a previously added PRI backhaul session.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.