Filter
Top Products
4-5
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 4 Configuring VISM Features
Connecting to Cisco MGX 8000 Series Platforms
1.17 Empty Clear
1.18 Empty Clear
1.19 Empty Clear
1.20 Empty Clear
1.21 Boot VISM-8T1 Clear
1.22 Empty Clear
1.25 Reserved VISM-8E1 Clear
1.26 Empty Clear
1.27 Empty Clear
1.28 Active VISM-8E1 Clear
1.29 Empty Clear
1.30 Empty Clear
1.31 Empty Clear
1.32 Empty Clear
NODENAME.1.7.PXM.a >
Step 8 Identify, from the list displayed in Step 7, the slot number of the VISM card you want to configure.
Step 9 Type the cc command (to change card), the VISM card slot number identified in Step 8, and press Enter.
The VISM card prompt is displayed. See the “VISM Card Prompt” section on page 4-5 for more
information.
You have completed logging in to the PXM and VISM cards and can now perform the mandatory initial
VISM card configuration. Proceed to the “Initial VISM Configuration” section on page 4-6.
VISM Card Prompt
The VISM card prompt is displayed when you successfully log in to a VISM card and has the following
format:
NODENAME.1.9.VISM8.a
The VISM card prompt contains the following data:
• Name of the MGX 8000 Series platform to which you are connected
• Number of the shelf—always 1
• Slot number
• Card type
• Card state—active (a) or standby (s)
Logging Out of VISM and PXM Cards
Enter one of the following commands to log out of the VISM and PXM cards:
• bye
• logout