Filter
Top Products
5-210
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfsesport
cnfsesport
To configure the port numbers of a previously added PRI backhaul session, use the cnfsesport command
in the VoIP switching/trunking operating mode.
cnfsesport session-num local-port-num remote-port-num
Syntax Description
Command Modes VoIP switching/trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that session number 4 is configured with local (VISM) port number 1200
and remote (call agent) port number 1204:
cnfsesport 4 1200 1204
Related Commands
session-num Identifying session number in the range from 1 to 64.
local-port-num Local port number. The VISM port number used for the session. It can be in
the range from 1124 to 65535.
remote-port-num Remote port number. The call agent port number used for the session. It can
be in the range from 1124 to 65535.
Command Description
cnfsesack Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
cnfsesmaxreset Configures the maximum number of resets that a VISM card performs before
a connection is reset.
cnfsesmaxseg Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
cnfsesnullsegtmout Configures the idle time before sending a null segment.
cnfsesoutofseq Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
cnfsesretrans Configures the timeout period for unacknowledged packets and the number
of retransmissions.
cnfsesstatetmout Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
cnfsessyncatmps Configures the maximum number of call agent synchronization attempts.