Filter
Top Products
5-143
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfds0loop
cnfds0loop
To configure a loopback type for a specified line and DS0, use the cnfds0loop command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
cnfds0loop line-num ds0-num loopback-type
Syntax Description
Command Modes VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that the loopback type of line 2, DS0 12 is configured as remote:
cnfds0loop 2 12 2
Related Commands There are no related commands.
line-num Line number of the channel to be configured for a loopback type; in the range from
1 to 8.
ds0-num DS0 number of the channel to be configured for a loopback type. It can be a value
from one of the following ranges:
• 1 to 24 for T1 lines
• 1 to 31 for E1 lines
loopback-type The type of loopback to be used on the channel. It can be one of the following
values:
• 1 = No loopback
• 2 = Remote loopback
• 3 = Local loopback