Filter
Top Products
5-148
Cisco VISM Installation and Configuration Guide
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands
cnfendptcadence
cnfendptcadence
To configure cadence (digit tone) times for an endpoint, use the cnfendptcadence command in the VoIP
switching/trunking and AAL2 trunking operating modes.
cnfendptcadence endpt-num tone-on-time tone-off-time
Syntax Description
Command Modes VoIP switching/trunking and AAL2 trunking
Usage Guidelines Follow standard CLI procedures for this command.
Examples The following example shows that endpoint 20 is configured with 100 ms digit tone generation time
length and 100 ms silence time length between generated tones:
cnfendptcadence 20 100 100
Related Commands There are no related commands.
endpt-num Endpoint number. It can be a value from one of the following ranges:
• For template number 1:
–
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
• For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
• For template number 4:
–
For VISM-PR, from 1 to 144
tone-on-time Length of time (defined in milliseconds) a digit tone is generated. It can be in the
range from 2 to 9999. (Default = 75)
tone-off-time Length of time (defined in milliseconds) silence is maintained between digit tone
generation. It can be in the range from 0 to 9999. (Default = 75)