Juniper Networks J-Series Network Router User Manual


 
Table 43: Enabling Commit Scripts
CLI Configuration EditorJ-Web Configuration EditorTask
From the [edit] hierarchy level, enter
edit system scripts commit
1.
In the J-Web interface, select
Configuration>View and Edit>Edit
Configuration.
2.
Next to System, click Configure or
Edit.
3.
Next to Scripts, click Configure or
Edit.
4.
Next to Commit, click Configure or
Edit.
Navigate to the Commit level in the
configuration hierarchy.
Set the script file name:
set file commit-script.xsl
1.
Next to File, click Add new entry.
2.
In the File name box, type
commit-script.xsl.
3.
Click OK.
Enable the commit script filefor
example, commit-script.xsl.
Disabling Commit Scripts
If you do not want a commit script to run, you can disable it by deleting or
deactivating it in the configuration. Deleting a commit script permanently removes
it from the configuration. To run the script later, you must reenable the script as
described in Enabling Commit Scripts on page 90. Deactivating a commit script
disables the script until you activate it later.
To delete a commit script:
1. From configuration mode in the CLI, enter the following command:
user@host# delete system scripts commit filename.xsl
2. Commit the configuration:
user@host# commit
commit complete
To deactivate a commit script:
1. From configuration mode in the CLI, enter the following command:
user@host# deactivate system scripts commit filename.xsl
2. Commit the configuration:
user@host# commit
Defining and Enforcing Configuration Rules with Commit Scripts 91
Chapter 6: Automating Network Operations and Troubleshooting