Juniper Networks J-Series Network Router User Manual


 
Monitoring Interfaces and Traffic from the CLI
This section contains the following topics:
Using the monitor interface Command on page 245
Using the monitor traffic Command on page 246
Using the monitor interface Command
Use the CLI monitor interface command to display real-time traffic, error, alarm, and
filter statistics about a physical or logical interface. Enter the command with the
following syntax:
user@host> monitor interface (interface-name | traffic)
Replace interface-name with the name of a physical or logical interface. If you specify
the traffic option, statistics for all active interfaces are displayed.
The real-time statistics are updated every second. The Current delta and Delta columns
display the amount the statistics counters have changed since the monitor interface
command was entered or since you cleared the delta counters. Table 127 on page
245 and Table 128 on page 245 list the keys you use to control the display using the
interface-name and traffic options. (The keys are not case sensitive.)
Table 127: CLI monitor interface Output Control Keys
ActionKey
Clears (returns to 0) the delta counters in the Current delta column. The
statistics counters are not cleared.
c
Freezes the display, halting the update of the statistics and delta counters.f
Displays information about a different interface. You are prompted for the
name of a specific interface.
i
Displays information about the next interface. The Services Router scrolls
through the physical and logical interfaces in the same order in which they
are displayed by the show interfaces terse command.
n
Quits the command and returns to the command prompt.q or ESC
Thaws the display, resuming the update of the statistics and delta counters.t
Table 128: CLI monitor interface traffic Output Control Keys
ActionKey
Displays the statistics in units of bytes and bytes per second (bps).b
Clears (returns to 0) the delta counters in the Delta column. The statistics
counters are not cleared.
c
Using CLI Diagnostic Commands 245
Chapter 12: Using Services Router Diagnostic Tools