Filter
Top Products
■ To check the configuration, see “Verifying an RPM Configuration” on page 285.
Table 144: Configuring RPM Probes to Monitor BGP Neighbors
CLI Configuration EditorJ-Web Configuration EditorTask
From the [edit] hierarchy level, enter
edit services rpm bgp
1.
In the J-Web interface, select
Configuration>View and
Edit>Edit Configuration.
2.
Next to Services, click Configure
or Edit.
3.
Next to Rpm, select the Yes check
box and click Configure or Edit.
4.
Next to Bgp, click Configure.
Navigate to the Services>RPM>BGP
level in the configuration hierarchy.
Enter
set data-fill ABCD123
In the Data fill box, type ABCD123.
Specify a hexadecimal value (the range
is between 1 and 2048 characters) that
you want to use for the data portion of
the RPM probe—for example, ABCD123.
Enter
set data-size 1024
In the Data size box, type 1024.
Specify the data size of the RPM probe
in bytes, a value from 0 through
65507—for example, 1024.
Enter
set destination-port 50000
In the Destination port box, type 50000.
Configure port 50000 as the TCP port to
which the RPM probes are sent.
Enter
set history-size 25
In the History size box, type 25.
Specify the number of probe results to
be saved in the probe history—for
example, 25. The range is between 0
and 255, and the default is 50.
Enter
set probe-count 5 probe-interval 1
1.
In the Probe count box, type 5.
2.
In the Probe interval box, type 1.
Configure the probe count—for example,
5—and probe interval—for example, 1.
■
Probe count—Total number of RPM
probes to be sent for each test. The
range is between 1 and 15 and the
default is 1.
■
Probe interval—Wait time (in
seconds) between RPM probes. The
range is between 1 and 255, and
the default is 3.
Enter
set probe-type tcp-ping
In the Probe type box, select tcp-ping.Specify the type of probe to be sent as
part of the test—tcp-ping.
NOTE: If you do not specify the probe
type the default ICMP probes are sent.
Enter
set test-interval 60
1.
In the Test interval box, type 60.
2.
Click OK.
Configure a value between 0 and 86400
seconds for the interval between
tests—for example, 60.
284 ■ Configuring RPM with a Configuration Editor
J-series™ Services Router Administration Guide