Juniper Networks J-Series Network Router User Manual


 
The Connect USB-modem-connect page is displayed.
11. If CHAP is configured on the dialer interface used for the USB modem interface
at the router end, type the username and password configured in the CHAP
configuration in the User name and Password boxes. For information about
configuring CHAP on dialer interfaces, see Configuring CHAP on Dialer Interfaces
(Optional) on page 37.
12. Click Properties.
The USB-modem-connect Properties page is displayed.
13. In the Networking tab, select Internet Protocol (TCP/IP), and then click
Properties.
The Internet Protocol (TCP/IP) Properties page is displayed.
14. Click Advanced.
The Advanced TCP/IP Settings page appears.
15. Clear the Use IP header compression check box.
Connecting to the Services Router from the User End
To remotely connect to the Services Router through a USB modem connected to the
USB port on the router:
1. On the PC or laptop computer at your remote location, select
Start>Settings>Control Panel>Network Connections.
The Network Connections page is displayed.
2. Double-click the USB-modem-connect dial-up connection configured in
Configuring a Dial-Up Modem Connection at the User End on page 39.
The Connect USB-modem-connect page is displayed.
3. Click Dial to connect to the Services Router.
When the connection is complete, you can use Telnet or SSH to connect to the
router.
Administering USB Modems
This section contains the following topics:
Modifying USB Modem Initialization Commands on page 41
Resetting USB Modems on page 42
40 Administering USB Modems
J-series Services Router Administration Guide