Juniper Networks J-Series Network Router User Manual


 
Table 101: CLI Request System Reboot Command Options (continued)
DescriptionOption
Specifies the time at which to reboot the router. You can specify time in one of the
following ways:
nowReboots the router immediately. This is the default.
+minutesReboots the router in the number of minutes from now that you specify.
yymmddhhmmReboots the router at the absolute time on the date you specify.
Enter the year, month, day, hour (in 24-hour format), and minute.
hh:mmReboots the router at the absolute time you specify, on the current day.
Enter the time in 24-hour format, using a colon (:) to separate hours from minutes.
at time
Specifies the number of minutes from now to reboot the router. This option is a
synonym for the at +minutes option.
in minutes
Specifies the boot device to boot the router from:
compact-flashReboots from the internal compact flash. This is the default.
removable-compact-flashReboots from the optional external compact flash. This
option is available on J2320, J2350, J4300, and J6300 Services Routers only.
usbReboots from the USB storage device.
media type
Provides a message to display to all system users before the router reboots.
message "text"
Halting a Services Router with the CLI
You can use the request system halt CLI command to halt the Services Router:
user@host> request system halt <at time> <in minutes> <media type> <message text>
When the router is halted, all software processes stop and you can access the router
through the console port only. Reboot the router by pressing any key on the keyboard.
NOTE: If you cannot connect to the router through the console port, shut down the
router by pressing and holding the power button on the front panel until the POWER
LED turns off. After the router has shut down, you can power on the router by pressing
the power button again. The POWER LED lights during startup and remains steadily
green when the router is operating normally.
Table 102 on page 196 describes the request system halt command options.
Table 102: CLI Request System Halt Command Options
DescriptionOption
Same as at now (stops software processes on the router immediately).
none
196 Rebooting or Halting a Services Router
J-series Services Router Administration Guide