Juniper Networks J-Series Network Router User Manual


 
probe for Customer B uses HTTP packets and sets thresholds and corresponding
SNMP traps to catch excessive lost probes. To configure these RPM probes:
1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
2. Perform the configuration tasks described in Table 141 on page 277.
3. If you are finished configuring the network, commit the configuration.
4. Go on to one of the following procedures:
To configure a TCP or UDP probe, see Configuring TCP and UDP
Probes on page 279.
To tune a probe, see Tuning RPM Probes on page 282.
To check the configuration, see Verifying an RPM Configuration on page 285.
Table 141: Configuring Basic RPM Probes
CLI Configuration EditorJ-Web Configuration EditorTask
From the [edit] hierarchy level, enter
edit services rpm
1.
In the J-Web interface, select
Configuration>View and
Edit>Edit Configuration.
2.
Next to Services, click Configure
or Edit.
3.
Next to Rpm, select the Yes check
box.
4.
Click Configure.
Navigate to the Services>RPM level in
the configuration hierarchy.
1.
Enter
set probe customerA
2.
Enter
set probe customerB
1.
In the Probe box, click Add new
entry.
2.
In the Owner box, type customerA.
3.
Click OK.
4.
Repeat the previous steps and add
an RPM probe owner for
customerB.
Configure the RPM owners customerA
and customerB.
Configuring RPM with a Configuration Editor 277
Chapter 14: Configuring RPM Probes