Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 4-55
Section 4. Programming Reference
PN 9001081
Rev. C
Special Notes
1. If Vertical and Horizontal position is not specified in the command, all data
preceding the command will be mirrored.
2. This command can be used with the <ESC>% Rotate Fixed Base Reference
Point command (see Page 5-70). It cannot be used with the <ESC>R
Rotate Moving Base Reference Point command (see Page 5-72). Please
note that the reference point rotation is dependent upon the location of the
<ESC>% command in the data stream.
3. This command should not be specified more than once in any single job.
4. This command cannot be used with commands requiring re-editing of the
print area such as Sequential Numbering, Real time clock, or Copy Image
Area.
5. Any data outside the printable area is not mirrored and the command is
treated as a command error. Any print job containing the <ESC>RM
command and without any print data will be treated as a command error.
Printer Output