Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 2-17
Section 2. Installation and Configuration
PN 9001081
Rev. C
DSW3
ON
OFF
1 2 3 4
5 6 7 8
DSW3-6 DSW3-7 SETTING
Off Off Type 4
Off On Type 3
On Off Type 2
On On Type 1
External Signal Type Selection (DSW3-6 and DSW3-7): Selects the type of
output signal. See page 5-13 for a description of signal types.
DSW3
ON
OFF
1 2 3 4
5 6 7 8
DSW3-8 SETTING
Off Disabled
On Enabled
Repeat Print via External Sign (DSW3-8): Allows an external device to control
the reprint of the label in the print buffer. See page 5-12 for a description of the
signal requirements.
Dip Switch Settings
Printer Setup
RS232 Transmit/Receive Setting
(Located on RS232S Serial Interface Card)
DSW1
ON
OFF
1 2 3 4
5 6 7 8
DSW1-1 SETTING
Off 8 data bits
On 7 data bits
Data Bit Selection (DSW1-1): This switch set the printer to receive either 7 or
8 bit data bits for each byte transmitted.
DSW1-2 DSW1-3 SETTING
Off Off No Parity
Off On Even
On Off Odd
On On Not Used
Parity Selection (DSW1-2 and DSW1-3): Selects the type of parity used for
error detection.
DSW1
ON
OFF
1 2 3 4
5 6 7 8