Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 4-69
Section 4. Programming Reference
PN 9001081
Rev. C
Reverse Image
Special Notes
1. A reverse image area is affected by the rotate commands. Therefore,
always assume the printer is in the normal print orientation when designing
and sending the Reverse Image command.
2. If using reverse images with the form overlay, place this command before
the Form Overlay command in the data stream.
3. If the Rotate commands are used with this command, the V and H
parameters are reversed.
4. If the height and width to be reversed contain other than alphanumeric
data, the area is not printed.
5 If the values specified exceed the maximum ranges, the reverse image is
not created.
6. The maximum allowable settings are as follows:
VR0095-M
latnoziroH
aaaa
9680ot1000
lacitreV
bbbb
4241ot1000