Filter
Top Products
PN 9001081
Rev. C
SATO M-5900RV Operator and Technical Reference Manual
Page 2-26
Section 2. Installation and Configuration
This setting determines if a zero is printed with a slash or without a slash. This setting can
also be controlled via software commands. When YES is selected, the U, S, M, WB, WL,
XU, XS, XM, XB, XL and vector fonts will have a slash through the center of the zero
character.
To access this setting, perform the following steps:
STEP PROCEDURE
1. From the Advanced Mode Setup, press the FEED key to move to the
Zero Slash display.
2. Use the LINE key to step the underlined cursor to either YES or NO.
3. Once the correct setting is underlined, press the FEED key to accept
the setting and advance to the Auto Online display.
This setting determines the mode in which the printer powers up. If the YES selection is
made, the printer powers up in the ONLINE mode and is ready to print. If NO is
selected, the printer powers up in the OFFLINE mode and must be manually placed in
the ONLINE mode by pressing the LINE key before it is ready to print.
To access this setting perform the following steps:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either YES or
NO.
2. Once the correct setting is underlined, press the FEED key to
accept the setting and advance to the Vertical Offset display.
Auto Online Setting
Zero Slash Setting
Advanced Mode
advanced mode
setup
zero slash
yes no
auto online
yes no
Feed
Key