Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 2-19
Section 2. Installation and Configuration
PN 9001081
Rev. C
Switch Selections
All switches are placed in the Off position (default) for shipping. This will result in the
following operating configuration:
Communications:
(1)
8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol:
(1)
Ready/Busy
Sensor: Gap Sensor
Receive Buffer: Single Job
Mode: Batch Continuous
Label Sensor: Sensor Used
Backfeed: Disabled
External Signals: Disabled
(1) Active only if an RS232 Interface Card is installed in the printer.
Software Default Settings - The printer stores any software settings upon receipt
from the host and uses them until they are again changed by receipt of a command
containing a new setting. These settings are stored in non-volatile RAM and are not
affected by powering the printer off. The printer may be reset to use the default
software settings by depressing the LINE and FEED keys simultaneously while
powering the printer on. This will result in the following default configuration:
retemaraPsgnitteStluafeD
ssenkraDtnirP"3"
deepStnirP.cesrep.ni3
ecnerefeRtnirP1000=latnoziroH,1000=lacitreV
oreZhsalS
eniL-nOotuAdelbanE
Once the default operation is completed, a DEFAULT SETTING COMPLETED
message will be displayed on the LCD panel and a single "beep" will be heard. The
printer should be powered off while this message is being displayed. This saves the
default settings in the EEPROM where they will be automatically loaded the next time
the printer is powered on.
DEFAULT SETTING
COMPLETED
2.9 Default Settings